ABAQUS Volume II: I–Z - Manual (Page 104)

*JOINT PLASTICITY
7. First field variable.
8. Second field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than two):
1. Third field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the plastic behavior as a function of
temperature and other predefined field variables.
Data lines for TYPE=CLAY:
First line:
1. , undrained shear strength of the clay.
2. a, hardening parameter.
3. b, hardening parameter.
4. c, hardening parameter.
5. Temperature.
6. First field variable.
7. Second field variable.
8. Third field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than three):
1. Fourth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the plastic behavior as a function of
temperature and other predefined field variables.
Data lines for TYPE=MEMBER:
First line:
1. , compressive capacity.
2. , tensile capacity.
3. , horizontal capacity.
4. , moment capacity.
5. Temperature.
6. First field variable.
7. Second field variable.
8. Third field variable.
10.3–2
ABAQUS Version 6.1 Module: ID:
Printed on: