GE Industrial Solutions 6KCV300DVN - Manual (Page 61)

6KCV300DVN
6
61
———— FUNCTION ERROR CODES ———
6.0 FUNCTION ERROR CODES
The following table shows the different error codes which could be generated
when a service is executed.
Meaning:
Parameter not exist The specified parameter does not exist.
Control Access denied The access is denied because of the Drive
condition.
Attribute Access denied The parameter attributes do not allow the
access.
RESULT VALUE
OK no error 0000H
Parameter not exist 0001H
Reserved 0002H
Control Access denied 0003H
Reserved 0004H
Attribute Access denied 0005H
Type value error 0006H
Reserved 0007H-000FH
Destination option not exist 0010H
Parameter Access Conflict 0011H
Value out of the maximun range 0012H
Value out of the minimun range 0013H
Value not supported 0014H
Parameter Configuration Conflict 0015H
Command Submitted 0016H
Reserved 0017H
Unknown Command 0018H
Read only Parameter 0019H
Write not allowed 001AH
Value out of constant limits 001BH
State not correct 001CH
Password 001DH
Type Unknown 001EH
Hardware Fail 0030H
Checksum Fail 0031H
Reserved 001FH-007CH
Reserved 0082H-00FCH
NOK generic 00FFH
User defined 0100H-FFFFH
t6000