GE Industrial Solutions 6KCV300DVN - Manual (Page 73)

6KCV300DVN
7
73
———— KEYBOARD INTERFACE ———
7.7.1 Display node address (MAC ID)
The node address (MAC ID), set by Dip-Switches, is displayed.
7.7.2 Display baud rate
The current Baud Rate of the node, set by Dip-Switches, is displayed.
7.7.3 Node status
The following node status are displayed:
· DNet Status.
· DNet StAux.
· DNet StUser.
By pressing the ENTER key, these three error-conditions are set to zero.
In normal conditions all must be set to zero; when pressing th ENTER key, all
error conditions are set to zero; if after this, the values are different from zero,
it means that an error occurred; even if these states are different from zero, the
PLC Master may be connected anyway.