GE Industrial Solutions 6KCV300DVN - Manual (Page 62)

GEI-100431
———— FUNCTION ERROR CODES ———
6 62
Type value error The type of specified value is wrong.
Destination option not exist The destination option does not exist on
the knot.
Parameter Access Conflict The access to the addressed parameter is
denied (for example if we have a writing
command and the parameter is connected
to an external input).
Value out of the max range The value is out of the maximum range.
Value out of the min range The value is out of the minimum range.
Value not supported The value is included in the range but it is
not allowed.
Parameter Configuration Conflict The access to the addressed parameter is
denied because of a system configuration
conflict.
Command Submitted The command has been transmitted but it
is not possible to know if it has been carried
out.
Unknown Command The command is unknown.
Read only Parameter The parameter has an only reading
attribute.
Write not allowed The writing function is not allowed
because of the slave conditions.
Value out of constant limits The value is out of the constant limits.
State not correct The control state does not allow the
command to be carried out.
Password The command has not been carried out
because the password is active.
Type Unknown The parameter type is unknown.
Hardware Fail The access is denied because of a hardware
failure.
Checksum Fail The access is denied because of a
checksum error.
NOK generic The access is denied because of a non
specified error.