GE Industrial Solutions 6KCV300DVN - Manual (Page 70)

GEI-100431
———— KEYBOARD INTERFACE ———
7 70
If the Password is correct, the following message will be displayed:
Password OK TSB8090
This message automatically disappears after two seconds, or upon pressing
the Cancel key.
If the Password is incorrect, the following message will flash:
Password wrong TSB8100
This message is removed by pressing the Cancel key.
7.6.2 Edit for the password setting
The flowchart illustrating Password Setup Editing is shown below. Note that
pressing Cancel at any time returns to the previous Menu or cancels the operation
in course. Refer to chapter 7.8 for Editing.
This menu is used to set the Password. Please note the following:
1) The default value is 0 (zero) and is equivalent to disabling the Password.
2) Entering a non-zero value via this Menu automatically enables the
Password.
3) Enter 0 (zero) to disable the Password.
4) If the Password is enabled, it also becomes active when the “OPTION1”
menu is accessed. As soon as it is attempted to access a Password protected
Menu or menu item, the Password will be requested. If the Password is
correctly entered, it will be deactivated from that moment on, i.e. it is
possible to access other protected Menus and/or menu items without having
to specify the password again.
5) The Password is automatically reactivated when the 6KCV300DVN card
Main Menu is exited.
The following message is displayed to confirm the Password:
Password: XXXXX
Conf. (+yes / -no) TSB8110
Pressing the “+” key confirms the Password and the system returns to the
immediately superior Menu level; from this moment on, the Password is enabled
if a non-zero value was entered or disabled if zero was specified.