Teledyne LeCroy WavePro Automation Command - Manual (Page 207)

Automation Command and Query Reference Manual - Control Reference
AdvancedMode Bool
If true, advanced mode is enabled, which enables the Advanced tab, and enables the selective
Gain/Offset and Deskew calibrations.
Description
CalibrateAll1 Action
Initiate full calibration of channel 1, which includes Gain/Offset, and deskew.
(Note that this action pops up an interactive wizard, which requires a user to manually dismiss)
Description
CalibrateAll2 Action
Initiate full calibration of channel 2, which includes Gain/Offset, and deskew.
(Note that this action pops up an interactive wizard, which requires a user to manually dismiss)
Description
CalibrateAll3 Action
Initiate full calibration of channel 3, which includes Gain/Offset, and deskew.
(Note that this action pops up an interactive wizard, which requires a user to manually dismiss)
Description
CalibrateAll4 Action
Initiate full calibration of channel 4, which includes Gain/Offset, and deskew.
(Note that this action pops up an interactive wizard, which requires a user to manually dismiss)
Description
CalSource Enum
Defines the calibration source. Can be the Auxiliary output, or, if connected, the TF-DSQ board.
Description
Values
AUXOUT
FastEdge
Clear1 Action
Clear all calibration coefficients for Channel 1.
Description
Clear2 Action
Clear all calibration coefficients for Channel 2.
Description
Clear3 Action
Clear all calibration coefficients for Channel 3.
Description
1-193
918501 RevA