Teledyne LeCroy WavePro Automation Command - Manual (Page 468)

Automation Command and Query Reference Manual - Control Reference
IsActive Bool
True if TriggerScan is currently active.
Description
LoadSelected Action
Load the trigger setup selected in the trigger list into the current trigger setup.
Description
LoadSetup Action
Load the trigger list from the file specified in the SetupFileName control.
Description
SaveSetup Action
Save the current trigger list into the file specified in the SetupFileName control.
Description
SetupFileName FileName
Any number of characters Range
Full pathname to a file which will be used by the LoadSetup/SaveSetup controls to load/save
triggerscan setups.
Description
StartScan Action
Start scanning. Places the scope in Normal trigger mode, and starts walking down the list of trigger
setups.
Description
StartTraining Action
Start Training. This will take an acquisition on the channel specified in the TrainerSource control, and
depending upon the state of the TrainEdges, TrainGlitches, TrainIntervals, TrainRunts, TrainWidths
controls, creates a list of trigger setups.
Description
StopOnTrigger Bool
If True, TriggerScan will stop scanning/acquiring upon the first trigger that occurs while scanning.
Description
StopScan Action
Stop Scanning.
Description
TrainEdges Bool
If True, Edge Trigger setups will be created during the training process.
Description
1-454
918501 RevA