Teledyne LeCroy WavePro Automation Command - Manual (Page 277)

Automation Command and Query Reference Manual - Control Reference
Persistence3d Bool
Changes the persistence map from a two-dimensional surface with brightness or color indicating the
third dimension, to a perspective rendering of a three dimensional object, where the third dimension is
shown as height above the surface formed by points which are not lit. In 3d, that surface is same
color or brightness as points with one or very few hits so that the surface is visible; but that means
points with one or very few hits cannot be distinguished from the background. See also
Persist3DQuality, which controls the appearance of the 3D object.
Description
PersistenceMonoChrome Bool
When this control is false (the default state), persistence is color graded. When this control is set to
true, persistence is monochrome, in the color of the trace, and increasing number of hits is shown as
increasing brightness. This control only has an effect when Persisted is true.
Description
PersistenceSaturation Integer
From 0 to 100 step 1 Range
Sets/Queries the saturation threshold for persisted waveforms.
All information at this level or above will be recorded with the same color or intensity.
See the general description above for a discussion of the locked and unlocked persistence modes.
Description
PersistenceTime Enum
Sets/Queries the state of the Persistence Time control. Controls the persistence decay time for this
trace. See the general description above for a discussion of the locked and unlocked persistence
modes.
Description
Values
0.5s
10s
1s
20s
2s
5s
Infinite
ShowLastTrace Bool
Sets/Queries the state of the Show Last Trace control. If True then when this trace is displayed in
persistence mode the last acquired waveform will be superimposed on the accumulating persistence
map.
See the general description above for a discussion of the locked and unlocked persistence modes.
Description
1-263
918501 RevA