Teledyne LeCroy WavePro Automation Command - Manual (Page 304)

Automation Command and Query Reference Manual - Control Reference
PATTLEN app.SDA2.JitterMeasure.Parameters.PattLen
ClearSweeps Action
Clear any accumulated result data. Useful for example to restart an average, or parameter statistics.
Description
View Bool
Sets/Queries the trace's 'Viewed' state. When true, the trace is displayed on one of the display
graticules. Note that even when a trace is not visible, it may be used as a source for Math, Measure,
etc.
Description
ClearSweeps Action
View Bool
PJ app.SDA2.JitterMeasure.Parameters.Pj
Pj is uncorrelated periodic (or sinusoidal) jitter. It is always computed from a spectrum of jitter after DDj terms have
been removed. (If the Jitter Method is Spectral, then in addition Rj is computed from the spectrum as all the energy
that was not in identified PJ peaks. See app.SDA2.JitterMeasure.Parameters.JitterModel for more information about
that).
ClearSweeps Action
Clear any accumulated result data. Useful for example to restart an average, or parameter statistics.
Description
View Bool
Sets/Queries the trace's 'Viewed' state. When true, the trace is displayed on one of the display
graticules. Note that even when a trace is not visible, it may be used as a source for Math, Measure,
etc.
Description
ClearSweeps Action
View Bool
RESULT app.SDA2.JitterMeasure.Parameters.Pj.Out.Result
RJ app.SDA2.JitterMeasure.Parameters.Rj
ClearSweeps Action
View Bool
1-290
918501 RevA