Teledyne LeCroy WavePro Automation Command - Manual (Page 27)

Automation Command and Query Reference Manual - Control Reference
Mode Enum
Sets/Queries the output mode of the AUX OUT connector. (Applicable to WM, SDA, DDA, WP series
of scopes)
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.XStreamDSO")
' Set the output of the AUX OUT connector to output
' a pulse on a pre-determined Pass-Fail decision.
app.Acquisition.AuxOutput.Mode = "PassFail"
Example
Values
DCLevel Emit a DC level
Off Output Disabled
PassFail Pulse-out controlled by Pass/Fail system
Square Square-wave signal generator
TriggerEnabled Pulse-out when trigger is enabled
TriggerOut Pulse-out when trigger occurs
SetToDefault Action
Set the Aux Output controls to their default values.
Description
CHANNELS app.Acquisition.Channels
This group of variables controls the acquisition channels C1, C2, C3 and C4.
Names of the form app.Acquisition.Channels.xxxx are aliases of simpler names which are described in the section of
the manual which is devoted to app.Acquisition. Examples of alias pairs are as follows -
app.Acquisition.Channels("Cx") is equivalent to app.Acquisition.Cx
app.Acquisition.Channels(1) is equivalent to app.Acquisition.C1
app.Acquisition.Channels("Cx").Out.Result is equivalent to app.Acquisition.Cx.Out.Result
Set app = CreateObject("LeCroy.XStreamDSO")
For X = 1 To 4
app.Acquisition.Channels(X).VerScale = 0.2
Next
Example
CX app.Acquisition.Cx
This group of variables controls the input channels C1, C2, C3 and C4.
Names of the form app.Acquisition.Channels.xxxx are aliases of simpler names which are described in the section of
the manual which is devoted to app.Acquisition. Examples of alias pairs are as follows -
app.Acquisition.Channels("Cx") is equivalent to app.Acquisition.Cx
app.Acquisition.Channels("Cx").Out.Result is equivalent to app.Acquisition.Cx.Out.Result
ActiveInput Enum
1-13
918501 RevA