ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 12)

Safety Information
9
 Look for damage to the tubing and/or the presence of air inside the
tubing.
 Inspect, and tighten if necessary, each Luer fitting (do not use
instruments to tighten the fittings).
5. Inspect the tubing that returns to the pump from the patient.
6. Examine the saline bag to ensure that it has not been accidentally
compromised (for example, the spike may have damaged the bag wall).
7. Inspect the tubing from the saline bag to the saline reservoir and the
pump.
Interference
If this equipment does cause interference with other devices, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
 Reorient or relocate the receiving device.
 Increase the separation between the equipment.
 Connect the equipment into an outlet on a circuit different from that
to which the other device(s) is connected.
Product Label
An identifying label is attached to the outside of the System console near the
power cord inlet. The label is illustrated in Figure 1-1.
Figure 1-1. Product Label .
The label provides safety information and identifies the manufacturer, model
number, serial number, power requirements, fuse capacity, and manufacturing
date for the System.
600479-001 Rev 2 12/147