ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 98)

Accesories - HMIA
4
Figure 1 Cables and Connections
The other end of the Alsius interface cable plugs into the HMIA connector
labelled T1 out. (See Figure 2).
Figure 2 HMIA with T1 out connection
To begin operation
The operation of the HMIA is very simple. There is no independent on/off switch.
As soon as the System is switched on, the HMIA automatically begins
functioning.
Connect the custom Alsius interface cable to the patient cable of the hospital
monitor. (See Figure 1). Plug the other end of the Alsius interface cable into the
HMIA connector labelled “T1 out”.
600479-001 Rev 2 98/147