Changing treatment mode – ZOLL Thermogard XP IVTM System Operation Manual User Manual
Page 43
Advertising
Operation
12
3.
The target temperature setting is updated on the Operating screen.
Changing Treatment Mode
As explained above, there are three treatment modes: “MAX”, “Controlled
Rate” and “FEVER”. To select the Treatment Mode, including one particular
value of “Controlled Rate” you use the “Rate Deg/Hr” button.
1. Press
the
“Rate Deg/Hr”r button once. If you are in RUN, you will be
taken to STANDBY. The Treatment Mode value may only be changed in
STANDBY.
Figure 4-7. Change Rate/Mode Temperature in RUN
2.
Turn the knob until the desired Treatment Mode selection is displayed.
When the correct selection is displayed, press the knob once to enter the
selection.
600479-001 Rev 2 43/147
Advertising