ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 134)

Maintenance
4
Scheduled Maintenance
The following table lists scheduled maintenance tasks for the System. Detailed
procedures for some of these tasks are listed later in this chapter.
Table 8-1. Scheduled Maintenance.
Item Frequency Maintenance Task
Coolant reservoir Before each use Inspect and refill with distilled water to
indicated line if necessary.
Condensate pan After each use Inspect. Empty condensate if necessary (refer
to the “Clean Console and Condensate Pan”
section of this chapter).
Refrigeration condenser
filter Every 6 months Inspect the filter and replace if necessary
(refer to the “Inspect/Replace Condenser
Filter” section of this chapter).
Roller pump Monthly Clean rollers and tubing path with cloth
moistened with water.
Clean rollers and apply light lubri-cating oil if
rollers have been in contact with saline
solution.
Coolant Annually Drain and refill with new coolant mixture.
Power cord Annually Inspect for wear or damage.
Temperature accuracy Annually Perform a temperature accuracy test (refer to
the “Temperature Accuracy Test” section of
this chapter).
NOTE TO INFECTION CONTROL:
50% propylene glycol coolant has been evaluated for antimicrobial
effectiveness and determined not to promote growth of gram negative rods,
gram positive cocci, or yeast microbes. 50% propylene glycol was found to
be comparable to 70% isopropyl alcohol.
600479-001 Rev 2 134/147