ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 99)

Accesories - HMIA
5
The set-up is now complete.
Controls and indicators on the HMIA
The HMIA has the following control/indicators: a reset switch, a green power
indicator and a red warning light.
The front panel of the HMIA is illustrated in the figure below.
Figure 3 Front Panel of the HMIA
The meaning of the symbols on the front panel are as described in the table
below
Table 1 HMIA Control/Indicators
Symbol Description Function
RST Reset Button This is a reset button. Lightly push the tip of a
paperclip, or similar sized device, into the hole
until you feel a “click” and then withdraw the
paper clip.
Caution LED This red light indicates that there is a
malfunction in the HMIA.
Power LED This green light indicates that the HMIA is
receiving power from the System.
RS232 RS-232 Serial port connector
cable This short extension cable is connected to the
RS-232 data port connector on the back of the
display head of the System.
T1 out Patient temperature output
connector This connector accepts the custom Alsius
interface cable.
SYSTEM System umbilical cord
connections One connector is attached to the round, multi-
pin connector on the back of the display head
of the System via a short cable. The other
connector mates with the umbilical cord of the
System.
600479-001 Rev 2 99/147