ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 29)

Receiving, Inspection & Assembly
5
Handle
2. Attach the handle to the mast using the long bolt and the short screw
provided. Use a 3/16-inch Allen wrench to tighten the bolt securely. Use
a 5/32-inch Allen wrench to tighten the screw (see figure 3-3). Do not lift
the System by the handle.
Figure 3-3. Use the Long Bolt and Center Screw to Attach the Handle.
Control Head
3. Carefully remove the control head from its packaging.
4. Attach the control head to the mast. Hold the pivot assembly perfectly
vertical and slide it into the mast opening by applying even, gradual
pressure. The pivot assembly fits into the mast only in one direction.
600479-001 Rev 2 29/147