ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 27)

Receiving, Inspection & Assembly
3
Receiving, Inspection, and Assembly
Overview
This chapter provides information on how to receive, unpack, and assemble the
System. If your System was delivered and set up by an ZOLL representative, you
may skip this chapter and turn to Chapter 4.
Inspection for Damage
Each System is carefully inspected before it is shipped. When the carrier
delivers your System, ensure that the shipping containers are not damaged.
Visually inspect the outside of the shipping container for any damage. If
damage is detected, please notify ZOLL’s customer service department and
file a damage claim with the carrier.
Required Tools
To safely unpack, inspect, and assemble the System, you will need the following
tools:
 Phillips screwdriver (included in shipping container).
 3/16-inch Allen wrench (included in shipping container).
 5/32-inch Allen wrench (included in shipping container).
 7/64-inch Allen wrench (included in shipping container).
 Scissors or box knife.
Unpacking
CAUTION! AVOID LIFTING INJURY.
The System weighs 115 lb (52 kg). Never attempt to lift the equipment without
assistance. Use safe lifting practice when handling the equipment.
To unpack the System, follow these steps in the indicated order.
1. Remove the straps from the carton and pallet.
2. Open the top flaps of the carton and remove the inner carton containing
the control head. This carton also contains the handle, attachment
hardware, spare fuses, the condensate pan, the saline container
insulating jacket, and other miscellaneous parts.
3. Remove the protective inserts and lift the outer carton up and off.
4. Use scissors or a box knife to carefully cut away the moisture barrier bag
surrounding the console. Use care to avoid scratching the console.
5. With the help of an assistant, grasp the base of the console just above
the casters, carefully lift the console off the platform, and set it on the
floor.
600479-001 Rev 2 27/147