Sony DAR-X1R - Manual (Page 118)

GB
118
Progressive Mode
DVD software can be divided into two types: film
based software and video based software. Video
based software is derived from TV and displays
images at 25 frames/50 fields (30 frames/60
fields) per second. Film based software is derived
from film and displays images at 24 frames per
second. Some DVD software contains both Video
and Film.
In order for these images to appear natural on your
screen when output in progressive mode (50 or 60
frames per second), the progressive video signal
needs to be converted to match the type of DVD
software that you are watching.
You can fine-tune the progressive 525p/625p
video signal that is output when you set
“Progressive Output” to “On.”
Note that you must connect to a progressive
format TV using the COMPONENT VIDEO OUT
jacks (page 30).
b Note
When picture noise appears after you set the recorder to
progressive format, hold down INPUT SELECT, and
press x on the recorder.
Scart Setting
Sets the method of inputting/outputting signals
from the SCART jacks on the rear panel of the
recorder. Select an option for each of the items
below according to the combination of jacks and
methods that you are going to use.
Line1 Output
Selects a method of outputting video signals for
the LINE 1 – TV jack.
b Notes
• If your TV does not accept S-video or RGB signals, no
picture appears on the TV screen even if you select “S
Video” or “RGB.” See the instructions supplied with
your TV.
• You cannot select “RGB” when “Component Out”
above is set to “On.”
• SMARTLINK is available only when “Video” is
selected.
Line3 Input
Selects a method of inputting video signals for the
LINE 3/DECODER jack. The picture will not be
clear if this setting does not match the type of
video input signal.
b Note
Input signals are recorded in video or RGB mode when
“Video/RGB” is selected.
Line3 Output
Selects a method of outputting video signals for
the LINE 3/DECODER jack.
Pause Mode (HDD/DVDs only)
Selects the picture quality in pause mode.
Auto Automatically detects the
software type (Film-based or
Video-based) and selects the
appropriate conversion mode.
Normally select this position.
Video Fixes the conversion mode to
the mode for Video-based
software.
RGB Outputs RGB signals.
Video Outputs video signals.
S Video Outputs S-video signals.
Video/RGB Inputs video signals or RGB
signals.
Decoder Select this when connecting to a
PAY-TV/Canal Plus analogue
decoder. If you connect to a
cable box/satellite receiver such
as CanalSat, do not select this
option.
S Video Inputs S-video signals.
Video Outputs video signals.
S Video Outputs S-video signals.
Auto The picture, including subjects
that move dynamically, is
output with no jitter. Normally
select this position.
Frame The picture, including subjects
that do not move dynamically,
is output in high resolution.