Sony DAR-X1R - Manual (Page 133)

Addi
tiona
l I
n
fo
rm
at
io
n
GB
133
Recording does not stop after you press x.
, Press x REC STOP.
Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more than
1 hour, reset the clock (page 116).
, Other timer setting overlapped the timer setting
(page 72).
, Disc space was not enough.
, The PDC/VPS function is working.
Contents previously recorded were erased.
, Data that is not playable on this recorder but was
recorded on a DVD with a PC will be erased
from the disc when the disc is inserted.
, “Auto Title Erase” of the “Timer Settings” in the
“Recording” setup is set to “On” (page 123).
The PDC/VPS function does not operate.
, Check that the clock and date are set correctly.
, Check that the PDC/VPS time you set is the
correct one (there might be a mistake in the TV
programme guide). If the broadcast you wanted
to record did not send the good PDC/VPS
information, the recorder will not start recording.
, If the reception is poor, the PDC/VPS signal
might be altered and the recorder might not start
recording.
, “PDC/VPS Scan Off” is selected (page 72).
, The PDC/VPS function may not work if the
GUIDE Plus+ host channel setup is not
complete.
, The PDC/VPS function does not work when the
GUIDE Plus+ data is being downloaded.
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
, You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 73).
, The recorder was not set to the Synchro-
Recording standby mode. Press
c z SYNCHRO REC to have the recorder stand
by for recording. Make sure the SYNC REC
indicator lights up on the front panel (page 73).
, The equipment is not connected to the LINE 3/
DECODER jack of the recorder.
, The recorder is connected to the TV output jack
of the connected equipment.
Synchro-Recording does not complete.
, The timer setting for the connected equipment
overlapped the recorder’s timer setting (page 74).
, There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
, The Synchro-Rec function was activated. Turn
off the satellite receiver and cancel the Synchro-
Rec function (page 73).
You dubbed a title, but the title did not appear
in the HDD Title List.
, The title contained a copy protection signal, so it
was moved (page 101).
High-speed dubbing is not possible.
, The title cannot be dubbed at high-speed
(page 100). Even if A-B erasure is performed so
that a title does not contain mixed picture sizes,
it is still treated as a title with mixed picture sizes.
Radio stations cannot be tuned in.
, Check that the aerial is connected securely.
Adjust the aerial or connect an external aerial if
necessary.
, The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
, No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations
(page 109).
, Press DISPLAY to display the frequency in the
front panel display.
, Keep the AM aerial away from the system and
other equipment (recorder, subwoofer, TV, etc.).
Recording from the equipment
with a timer
Dubbing
Tuner
,continued