Sony DAR-X1R - Manual (Page 24)

GB
24
Step 3: Preparing the
Remote
You can control the recorder using the supplied
remote. Insert two R6 (size AA) batteries by
matching the 3 and # ends on the batteries to the
markings inside the battery compartment. When
using the remote, point it at the remote sensor
on the recorder.
b Notes
• Use the batteries correctly to avoid possible leakage
and corrosion. Should leakage occur, do not touch the
liquid with bare hands. Observe the following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an extended
period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid inside
the battery compartment, and insert new batteries.
• Do not expose the remote sensor (marked on the
front panel) to strong light, such as direct sunlight or a
lighting apparatus. The recorder may not respond to the
remote.
You can adjust the remote’s signal to control your
TV.
b Notes
• Depending on the connected unit, you may not be able
to control your TV with some or all of the buttons
below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the code
number may be reset to the default setting. Set the
appropriate code number again.
1
Press the TV button to set the remote to the
TV mode.
2
Hold down [/1.
3
With [/1 pressed down, enter the TV’s
manufacturer code using the number
buttons.
For instance, to enter “09,” press “0” then “9.”
After you enter the last number, release [/1.
Controlling TVs with the remote
2 +/–
Number
buttons,
-/--
TV/DVD
[/1
TV
PROG +/–
</M/m/,,
TOOLS
SYSTEM
MENU
O RETURN