To be tested. see, Figure 522-1, Set for the particular ds1 to be tested. see – ADC Soneplex Broadband System User Manual
Page 96: Dlp-522, Page 2 of 2, Figure 522-1. test setup
Advertising
ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
2-73
© 2000, ADC Telecommunications, Inc.
DLP-522
Page 2 of 2
10. At the far end of the circuit, insert a DS1 test signal into the DS1 input using the DS1 test set.
11. Verify that all alarm indicators on the chassis are off and the DS3 test set with DS1 option
is receiving error-free data in the DS1 signal selected for test.
12. Repeat Steps 10 and 11 for all DS1 circuits to be tested.
Stop! You have completed this procedure.
6186-B
DSX-3
CROSS-CONNECT
DSX-1
CROSS-CONNECT
MON
OUT
IN
SONEPLEX
BROADBAND
CHASSIS
DS3
TX
RX
DS3 TEST SET
TX
RX
MON
OUT
IN
OFFICE EQUIPMENT
TX
RX
DS1 TEST SET
TX
RX
SONEPLEX
BROADBAND
CHASSIS
DLX
or
RLX
Figure 522-1. Test Setup
Advertising