Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual User Manual
Page 109
110
Rockwell Automation Publication 193-UM011A-EN-P - September 2010
Chapter 10 Using DeviceLogix™
11.
If programming the function block offline, exit the Function Block editor
and go online with the DeviceNetwork. Download the parameters,
including the DeviceLogix Function Blocks, to the EC4 and proceed to
step 12. If programming the function block online, download the
Function Blocks to the EC4 by selecting the Download button
or
through the Communications menu.
A dialog box will appear when the Function Blocks are successfully
downloaded to the EC4. Press OK to continue.
12.
Next, the DeviceLogix Function Blocks need to be enabled. This can be
done through a DeviceNet Configuration Terminal (Catalog Number
193-DNCT) or through RSNetWorx. When using RSNetWorx to enable
the DeviceLogix function blocks, select the Logic Enable On button
or through the Communications menu.
13.
Verify the functionality of the DeviceLogix Function Blocks by enabling
Input 1 on the EC4. When Input 1 is enabled, Output A will energize.