Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 141)

142 Rockwell Automation Publication 193-UM011A-EN-P - September 2010
Appendix B DeviceNet Information
115 Get Warning Status WORD Bit 0 = Reserved
Bit 1 = Overload
Bit 2 = Phase Loss
Bit 3 = Ground Fault **
Bit 4 = Reserved
Bit 5 = Jam
Bit 6 = Underload
Bit 7 = PTC **
Bit 8 = Current Imbal
Bit 9 = Comm Fault
Bit 10 = Comm Idle
Bit 11 = Reserved
Bit 12 = Config Fault
Bit 13 = PM Starts
Bit 14 = PM Oper Hours
116 Get Trip Log 0 WORD Last trip condition. Bit definitions of the
value are the same as attribute 114
117 Get Trip Log 1 WORD Last trip condition. Bit definitions of the
value are the same as attribute 114
118 Get Trip Log 2 WORD Last trip condition. Bit definitions of the
value are the same as attribute 114
119 Get Trip Log 3 WORD Last trip condition. Bit definitions of the
value are the same as attribute 114
120 Get Trip Log 4 WORD Last trip condition. Bit definitions of the
value are the same as attribute 114
121 Get Device Status WORD Bit 0 = Trip
Bit 1 = Warning
Bit 2 = OutputA
Bit 3 = OutputB
Bit 4 = Input 1
Bit 5 = Input 2
Bit 6 = Input 3
Bit 7 = Input 4
Bit 8 = Motor Current
Bit 9 = GF Current
124 Get/Set Trip Enable WORD Bit 0 = Reserved
Bit 1 = Overload
Bit 2 = Phase Loss
Bit 3 = Ground Fault **
Bit 4 = Stall
Bit 5 = Jam
Bit 6 = Underload
Bit 7 = PTC **
Bit 8 = Current Imbal
Bit 9 = Comm Fault
Bit 10 = Comm Idle
Bit 11 = Reserved
Bit 12 = Reserved
Bit 13 = Reserved
Bit 14 = Remote Trip
Bit 15 = Start Inhibit
125 Get/Set Warning Eanble WORD Bit 0 = Reserved
Bit 1 = Overload
Bit 2 = Phase Loss
Bit 3 = Ground Fault **
Bit 4 = Stall
Bit 5 = Jam
Bit 6 = Underload
Bit 7 = PTC **
Bit 8 = Current Imbal
Bit 9 = Comm Fault
Bit 10 = Comm Idle
Bit 11 = Reserved
Bit 12 = Device Config
Bit 13 = PM Starts
Bit 14 = PM Oper Hours
Table 58 - Control Supervisor Object Instance Attributes
Attribute
ID Access
Rule Name Data
Type Value