Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual - Manual (Page 33)

34 Rockwell Automation Publication 193-UM011A-EN-P - September 2010
Chapter 2 Installation and Wiring
Full-Voltage Non-Reversing (with Network Control)
Figure 21 - Full-Voltage Non-Reversing Starter Wiring Diagram (NEMA
Nomenclature)
Figure 22 - Full-Voltage Non-Reversing Starter Wiring Diagram (CENELEC
Nomenclature)
ATTENTION: Additional control circuit protection may be
required. Refer to the applicable electrical codes.
ATTENTION: Do not apply external voltage to 1T1, 1T2, or the
input terminals IN 1…4. This may cause equipment damage.
S.C.P.D.
E3 / E3 Plus
L 1 L 2
2/T1 4/T2 6/T3
M
T1 T2
S . C . P . D .
E3 / E3 Plus
L 1 L 2 L 3
2/T1 4/T2 6/T3
M
T1
T2
T3
M 9 5 9 6 A 1 A 2 1 4 1 3
O u t A Trip Relay ➊
E 3 E 3
➊ Contact shown with supply voltage applied.
Single-Phase Three-Phase
95
96
A 1
A 2
14
13
Out A
Trip Relay ➋
E 3
E 3
➋ Contact shown with supply voltage applied.
K
L1
N