Rockwell Automation 193-EC4 EC4 Current Monitoring Relay User Manual User Manual
Page 52
Rockwell Automation Publication 193-UM011A-EN-P - September 2010
53
DeviceNet Node Commissioning Chapter 4
Figure 28 - Node Commissioning Device Solution Window
3.
Select the EC4 Current Monitoring Relay located at node 63.
4.
Select “OK”. The Node Commissioning screen shows Current Device
Settings entries completed. It will also provide the current network baud
rate in the New EC4 Current Monitoring Relay Settings area. Do not
change the baud rate setting, unless you are sure it must be changed.
5.
Type the node address that you want in the New Device Settings section.
In this example, the new node address is 5.
6.
To apply the new node address, select “Apply”.
7.
When the new node address has been successfully applied, the Current
Device Settings section of the window is updated (see the example below).
If an error occurs, check to see if the device is properly powered up and
connected to the network.