Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 User Manual
Page 100
Publication 1404-UM001D-EN-E - October 2004
4-40 Communications
• PLC-5/xxE Series C/ Rev. N
• PLC-5/xxE Series D/ Rev. E
• PLC-5/xxE Series E/ Rev. D
• SLC 5/05 Series A FRN 5 (OS 501)
• SLC 5/05 Series C
Messaging from a PLC-5E or SLC 5/05 to a Powermonitor 3000 uses a
MultiHop message path. The client controller “thinks” it is
communicating with a ControlLogix controller. The example message
detail screens below indicate a PLC/5xxE reading the voltage and
current table F15:0 from a Powermonitor 3000 to the controller’s F15:0
data table.
Figure 4.5 PLC-5/xxE Message Detail Screen Example
When you select Yes in the MultiHop field, the MultiHop tab appears
in the dialog. Enter the IP address of the Powermonitor 3000 in the
1756-ENET I. P. field (192.168.4.49 is used here as an example) and
any integer in the 1756 backplane Slot field. See below.