Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 255)

1 Publication 1404-UM001D-EN-E - October 2004
Appendix
C
Sample Applications
Introduction This Appendix contains sample applications including ladder
diagrams to help you get started in setting up communications
between your application and a Powermonitor 3000.
The application samples depict basic methods for reading and writing
data between a Powermonitor 3000 and your programmable
controller or other application. Expand on these basic steps to
customize your application to meet your business needs. The sample
applications included are:
1. Read and write the Powermonitor 3000 system clock using a
variety of controllers, applications and communications
2. Read multiple Powermonitor 3000 data tables into a SLC 500
controller using DeviceNet communications
3. Set up the user-configured data table using a ControlLogix
controller and EtherNet/IP communications
4. Communications reading and writing Powermonitor tables using
an SLC and 1747-SCNR ControlNet scanner.
ATTENTION
Proper operation of the application is the
responsibility of the user. Rockwell Automation
makes no warranty, express or implied, for these
sample applications. The sample applications are
subject to change at any time without notice.