Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 User Manual
Page 45
Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 Operations 3-19
1. Using the four Display Module keys, move into Program mode
and display the command to be issued. Notice the flashing
phase indicators on the right-hand side.
Figure 3.5 Program Mode
2. Set the Display Module into Edit mode by pressing the Enter
key. Notice that the phase indicators on the right-hand side are
now solid and the command option prompt is now flashing.
Figure 3.6 Edit Mode
ATTENTION
The relay and KYZ outputs may be connected to
field devices. Before issuing a command to force an
output, ensure that any devices connected to outputs
cannot operate in an unsafe or undesired manner.
Failure to follow these instructions may result in
personal injury or death, property damage or
economic loss.
FORCE
UP-DN
L1
L2
L3
N
Powermonitor 3000
wermonitor 3000
RELAY
UP-DN
L1
L2
L3
N
Powermonitor 3000