Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 351)

Publication 1404-UM001D-EN-E - October 2004
Index 3
configuration options 7-2
configuring using communications 7-4
reading data using communications 7-5
user comment field for M8 7-6
viewing using the display module 7-2
event logging of status inputs 6-6
expressing data 4-18
expressing metered data 3-3
F
file data values C-21
forced operation 6-3
frequently asked questions E-1
H
harmonic analysis 8-6
configuring 8-10
crest factor 8-8
harmonic distortion 8-10
harmonic magnitude 8-10
IEEE THD and DIN 8-7
IEEE-519 TDD and IEEE-519 pass/fail 8-9
K-factor 8-8
reading data 8-11
reading individual values 8-12
TIF 8-8
harmonic distortion 8-10
harmonic magnitude 8-10
hours selection 7-16
I
I/O operations 6-1
I/O type communications 4-24
IEEE 519 Pass Fail 8-9
IEEE 519 TDD 8-9
IEEE THD and DIN 8-7
indexed reads 4-22
issuing commands 3-18
K
k factor 8-8
key functions 3-13
L
led indicators 2-10
load factor 8-16
reading the log 8-17
load factor log reading 8-17
M
master module 2-2
communications 2-2
configuration 2-2
metering accuracy class 3-3
metering functionality 3-1
configurable energy counter rollover 3-9
demand calculation 3-9
energy results 3-8
expressing metered data in the display
module 3-3
metering accuracy class 3-3
power factor results 3-7
power results 3-6
projected demand calculation 3-10
symmetrical component analysis results
3-5
viewing metered data using the display
module 3-3
voltage current and frequency results
3-4
metering update rate 3-33
min/max log 7-13
accessing using display module 7-13
interfacing using communications 7-14
Modbus 4-2
Modbus RTU slave protocol 4-26
multiple data table reads using
DeviceNet C-17
explicit message transfer setup C-17
SLC 500 sequencer operation C-20
N
network demand and time configuration
3-29
broadcast port 3-29
controller command 3-31
input mode 3-29
SNTP address 2 3-30
SNTP address 3 3-30
time IP address 3-30
time set interval 3-30
world time zone 3-30
no control operation 6-3
not equal setpoint 5-5
NVS Object
class attributes F-11
class specific services F-13
common services F-13
instance attributes F-12
instances F-14