Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 114)

Publication 1404-UM001D-EN-E - October 2004
4-54 Communications
Refer to User-Configured Data Table Setup Using ControlLogix and
EtherNet/IP on page C-27 for a sample ladder diagram and messages
used to configure and read the user-configured data table.
User-Configured I/O Table
You may configure Input Messaging Instance 1 in Powermonitor 3000
units with optional DeviceNet, EtherNet/IP (Series B), or ControlNet
communications in the same way as the user-configured data table
above. You have one additional option for Instance 1: you may select
the data type of Instance 1 as integer (0) or floating-point (1).
TIP
Refer to the Rockwell Automation Knowledgebase
(http://www.ab.com) for additional information on
setting up a user-configured I/O instance.