Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 102)

Publication 1404-UM001D-EN-E - October 2004
4-42 Communications
Figure 4.8 ControlLogix to Powermonitor 3000 Communication Tab Example
The first example below reads the Voltage and Current table from a
Powermonitor 3000 into the ControlLogix controller tag
dataPM3K_VI(0) using a PLC-5 Typed Read, configured as an array of
14 elements of type Real. You would configure a CIP Data Table Read
the same way except for the message type.
Figure 4.9 ControlLogix PLC-5 Typed Read Example
The next example shows the message configuration for a CIP Generic
message type. A CIP Generic message can read or write data,
depending on the Service Type you specify. Refer to DeviceNet class
services in the discussion above. In this example, the ControlLogix