Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 43)

Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 Operations 3-17
Scrolling
When messages are too large to fit on the display, a scrolling
mechanism is employed. The message scrolls horizontally. The default
scroll rate was chosen to give you enough time to see the message but
not take too much time to show the entire message. You may select
from two different scroll rates using the Advanced Configuration Menu
on the Display Module. Take care to see the entire message before
taking any action as some of the messages are very similar and differ
only by a few characters.
Editing a Parameter
1. Using the Display Module keys, move into Program mode and
display the parameter to be modified. Notice the flashing phase
indicators on the right-hand side of the screen.
Figure 3.3 Edit Mode
2. Set the Display Module into Edit mode by pressing the Enter
key. Notice that the phase indicators on the right side turn-on
solid and the parameter being modified is now flashing.
Figure 3.4 Parameter Change
PT.SEC
120
L1
L2
L3
N
Powermonitor 3000
PT.SEC
250
L1
L2
L3
N
Powermonitor 3000 wermonitor 3000