Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 202)

Publication 1404-UM001D-EN-E - October 2004
A-28 Powermonitor 3000 Data Tables
34 Setpoint #1 time accumulator
• • • Refer to Table A.20 Setpoint Output Actions
35 Setpoint #2 time accumulator
• • •
36 Setpoint #3 time accumulator • • •
37 Setpoint #4 time accumulator • • •
38 Setpoint #5 time accumulator
• • •
39 Setpoint #6 time accumulator
• • •
40 Setpoint #7 time accumulator
• • •
41 Setpoint #8 time accumulator • • •
42 Setpoint #9 time accumulator • • •
43 Setpoint #10 time accumulator • • •
44
Voltage Sag
(2)
• • Refer to Sag and Swell on page 8-13
45
Voltage Swell
(2)
• •
46
Transient detected
(2)
• Triggers a setpoint when a transient has been detected
47 Avg IEEE THD V
• • • Refer to Table A.34 Harmonic Results; THD, Crest Factor, and More .
48 Avg IEEE THD I
• • •
49 Avg IEC thd V
• • •
50 Avg IEC thd I • • •
51 Avg Crest Factor V • • •
52 Avg Crest Factor I
• • •
(1) A setpoint activates when the magnitude of any phase passes the activation limit and releases when all phases pass the release limit in the appropriate direction for the
setpoint evaluation condition.
(2) These setpoint types apply only to the applicable Powermonitor 3000 models and will appear as “inactive” on other models.
Param.
No. Parameter name M4
M5 M
6 M
8 Comment