Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 201)

Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 Data Tables A-27
Table A.19 List of Setpoint Types
Applies to: Refer to Table A.18 Setpoint Setup/Read-Back Select and Status
PM3000 Type See table
Param.
No. Parameter name M4
M5 M
6 M
8 Comment
0 Not used • • • Disables the setpoint.
1
Voltage
(1)
• • • Refer to Table A.9 Metering Voltage, Current and Frequency Result
2
Current
(1)
• • •
3 Voltage unbalance
• • • Refer to Table A.10 Metering Sequence Voltage and Current Results
4 Current unbalance
• • •
5 Neutral current • • •
6 W • • • Refer to Table A.11 Metering Power Results
7 VAR • • •
8 VA
• • •
9 Total true PF
• • • Refer to Table A.13 Metering Power Factor Results
10 Total disp PF
• • •
11 Total dist PF • • •
12 W demand • • • Refer to Table A.12 Metering Demand Results
13 VAR demand • • •
14 VA demand
• • •
15 Amp demand
• • •
16 Projected amp demand
• • •
17 Projected W Demand • • •
18 Projected VAR Demand • • •
19 Projected VA Demand
• • •
20 Frequency
• • • Refer to Table A.9 Metering Voltage, Current and Frequency Result
21 Phase rotation
• • • Refer to Table A.10 Metering Sequence Voltage and Current Results
22 Crest factor voltage • • • Refer to Table A.34 Harmonic Results; THD, Crest Factor, and More
23 Crest factor current • • •
24 Crest factor I4 • • •
25
IEEE THD voltage
(1)
• • •
26
IEEE THD current
(1)
• • •
27 IEEE THD I4
• • •
28
IEC THD voltage
(1)
• • •
29
IEC THD current
(1)
• • •
30 IEC THD I4
• • •
31 Status input 1
• • • Refer to Table A.3 Discrete Data
32 Status input 2 • • •
33
Any status input
(1) • • •