ADS Environmental Services Portable FlowShark Pulse QR 775006 A2 - Manual (Page 101)

6-2 ADS Portable FlowShark Pulse Manual
Basics for Setting Parameters
The unit’s protection is guaranteed only when the enclosure lid is closed and locked
securely using both locks. Therefore, always verify that the lid is locked safely using
both snap locks after setting the parameters, before initiating data logging activities,
and after verifying the initial readings.
During unfavorable weather conditions (such as rain) or at
locations experiencing water leakage from the top of the manhole,
seek a dry location in which to replace the battery pack or memory
card. When a dry location is not available, protect the exposed
(open) unit sufficiently from contact with moisture.
After setting the parameters, lock the unit securely using both snap
locks to guarantee protection from environmental elements.
The transmitter operates automatically using the existing settings until you enter and
confirm new input parameters. After finishing entering all the new settings, the
system will prompt you whether to accept the new values.
Confirming the new settings (selecting YES) requires you to enter the following code
number.
2718 Type in 2718 if prompted.
The unit will request the PIN once daily while you are setting the parameters. It also
will request the pin when an interruption of power to the unit occurs.
Do not give this code number to an unauthorized individual. In
addition, do not leave the code next to or write it down on the
equipment. This number prevents access by unauthorized users.
If you enter the wrong code three times, the system will abort the parameter mode and
continue operation based on the existing parameters. If the correct code is entered,
the system will accept the modified parameters and reset (which takes approximately
20 to 30 seconds).
After mounting and installing the sensor and transmitter, activate the power supply.
To activate the power supply, connect the plug in the battery compartment to the
socket at the end of the wire attached to the rechargeable battery.
The initial start-up dialog displayed requires you to select the language in which the
unit will display information.