ADS Environmental Services Portable FlowShark Pulse QR 775006 A2 - Manual (Page 116)

Parameter Settings 6-17
Due to the limited area for display, the entire menu cannot display on the screen. The
black scroll bar to the right of the menu options indicates that additional options are
available on the menu.
Use the up and down arrow keys to scroll through the menu.
Measurement Place Name
ADS recommends managing and designating names based on the names used in the
associated documentation. A name may contain up to 21 characters. The method
used for entering a name on this screen is similar to entering text on a cellular phone:
After selecting the Measurement Place Name submenu from the PAR menu, the
default setting, ADS, will display.
Setting the name for the measurement location
Enter the desired name using the keypad; each key represents three letters and a
number (Refer to Chapter 5, Initial Startup). Cycle through the characters by briefly
and repeatedly pressing a key. The cursor will proceed to the next character
automatically if the key has not been pressed for two seconds.
Following are descriptions of the function keys:
ALT This key allows you to select special characters (e.g., % or #) that are not
available on the keypad. While many characters will display, not all are
available for use in location names. Symbols also may be used to indicate
inputs and outputs. Select a specific character using the left or right arrow
keys, and confirm the selection by pressing Enter.
These keys move the cursor to the left or the right within the special character
menu. Pressing the right arrow creates a character representing a space (when
in the uppercase or lowercase menu). Pressing the left arrow deletes the
previous character.
Note: You can correct mistakes in characters by moving the cursor back and
overwriting the problem character.
These keys toggle between uppercase and lowercase letters. The up arrow
shifts to uppercase letters. The down arrow shifts to lowercase letters.
Pressing this key confirms the name entered and exits the menu.
Channel Shape(s)
Select the desired profile using the left and right arrow keys and confirm by pressing
Enter. The following standard profiles are available (according to ATV A110):
 Pipe (round or ellipse)
 Egg (standard; height-to-width ratio = 1.5:1)