ADS Environmental Services Portable FlowShark Pulse QR 775006 A2 - Manual (Page 136)

Parameter Settings 6-37
Sampling
This menu displays only when the water test function is enabled.
Relay settings for sampling

Duration (seconds) Enter the duration for the impulse. Modify this setting
based on the sampler in use.
 Volume [mgal] Enter the volume at which to close the contact for the
designated duration.
 Level [ft] Enter the depth beyond which to close the contact. This parameter
serves to protect the sampler from drawing in air.
The Portable FlowShark Pulse operates in continuous mode when
the water test function is selected. The designated memory cycle
will define the storage interval only for the compact flash card.
This ensures that sampling begin will immediately once the flow
reaches the designated volume.
In this mode, the unit has a battery life of approximately 3 days.
PAR: Setup Parameter
This menu allows you to either modify or restore the following basic settings of the
system.
Submenu for setup parameter
Load factory setup
This option enables you to execute a general reset. Selecting this option displays the
following screen: