ADS Environmental Services Portable FlowShark Pulse QR 775006 A2 - Manual (Page 95)

5-4 ADS Portable FlowShark Pulse Manual
The top of the display provides five basic menus for selection:

RUN This menu represents the standard mode of operation. In addition to
indicating the name of the measurement location, this menu allows you to
view time, flow rate, flow depth, average flow velocity (as well as flow
velocity distribution), daily totals, and error messages. It also includes a
function that enables you to record flow volume, flow depth, and average flow
velocity data.

PAR This is the most extensive menu on the Portable FlowShark Pulse. It
enables you to set the parameters for the measurement location, sensors,
memory mode, communications, and other factors.

I/O This menu provides information concerning the internal operation of the
Portable FlowShark Pulse and allows you to view all current readings.
Submenus display sensor echoes, individual velocity readings, and other data
for assessing the overall hydraulic conditions at the location. In addition, it
enables you to determine the remaining capacity on the optional memory card
and rechargeable battery.

CAL This menu allows you to calibrate flow depths and modify the settings
corresponding to depth calibration and low flow velocity parameters.

EXTRA This menu enables you to modify the basic display settings: contrast,
lighting, language, units, system times, and totalizer presets.
The Portable FlowShark Pulse enters into energy-saving standby
mode 4 minutes following the last keystroke. Therefore, the unit
will activate only within the set cycles.
The display is disabled when in storage (unattended use) mode. It
will remain disabled until the next keystroke.