ADS Environmental Services Portable FlowShark Pulse QR 775006 A2 - Manual (Page 76)

Installation 3-39
RMS 3
1 Fastening clip
2 Base plate BST
3 Extension sheet V5
4 Extension sheet V10
5 Scissors jack
Components included in the pipe mounting system 3
Inside Diameter BST Base Plate SPV Scissors Jack V5 Extension Plate V10 Extension
Plate
160 mm X
inner hole
X X
200 mm (8 inches) X
inner hole
X X
250 mm (10 inches) X
inner hole
X X X
300 mm (12 inches) X
outer hole
X X X
Table of mounting sheets for different pipe diameters
During assembly, always locate the scissors jack at the crown of the pipe and the base
plate at the bottom of the pipe. If air-ultrasonic and water-ultrasonic sensors are used
simultaneously, install the air-ultrasonic sensor at the pipe crown with the scissors
jack in immediate proximity. Use the extension sheets, when necessary, to the right-
hand and left-hand sides between the scissors jack and base plate.
The fastening clips ensure quick installation. Place them flush onto the mounting
plate against the direction of the flow.
The light-gauge metal sheets have sharp edges. Therefore, please
wear protective gloves when installing or disassembling the pipe
mounting system.