Welltech SIPIVR 6800GS V.2.1 - Manual (Page 84)

83
User ID Var: Variable to store user ID
ANI Var: Variable to store calling number
DNIS Var: Variable to store called number
GW ID Var: Variable to store gateway ID
Conf ID Var: Variable to store conference ID
Setup Time Var: Variable to store setup time (UTC time format)
Connected Time Var: Variable to store connected time (UTC time format)
Service
Type:
Login: The user should be connected
Framed: A Framed Protocol should be started for the user
Callback Login: The user should be disconnected and called back,
then connected to host.
Callback Framed: The user should be disconnected and called back,
and then a Framed Protocol should be started for the user.
Outbound: The user should be granted access to outgoing devices
Administrative: The user should be granted access to the
administrative interface to the NAS from which privileged commands
can be executed.
NAS Prompt: Network access server
Authenticate Only: Only Authentication is requested, and no
authorization information needs to be returned in the Access-Accept
(typically used by proxy servers rather than the NAS itself)
Callback NAS Prompt: The user should be disconnected and called
back, then provided a command prompt on the NAS from which
non-privileged commands can be executed
Disconnected Time Var: Variable to store disconnected time. (UTC time
format)
Disconnected Cause Var: Variable to store disconnected cause.
Remote
Address Var: Variable to store remote address
Acct Session Time Var: Variable to store acct session time
Acct Session ID Var: Variable to store Acct Session ID
Call Type: Protocol type or used on this leg of the call
Telephony
VOIP
Call Origin: The gateway’s behavior in relation to the connection that is
active for this leg
Originate
Answer
Next Goto: Next component to be executed
5.22 Send Event
[Introduction]
Send the event and related parameters to the component Wait Event. The
wait event
could be on another channel or same channel. The event name
should be same in between Send Event and Wait Event components.
[Description]
Right-click Send Event component, the screen appears as Figure 5-22.