ARAG Bravo 400S Crop sprayer - Manual (Page 15)

15
7 SETUP
7.1 Setup preparation
Before computer setup, check:
• that all components are correctly installed (control unit and sensors);
• the correct connection to the power source;
• the correct connection of components (control unit and sensors).
Failure to correctly connect system components or to use specified components might damage the device or its components.
7.2 Switching on
 
Fig. 23
SOFTWARE VERSIONS
Fig. 24
Keep key pressed until Bravo 400S
displays the screen shown in Fig. 23.
The software version is shown
immediately afterwards (Fig. 24).
FIRST DEVICE SWITCHING ON

Fig. 25 Fig. 26
Upon first switching on, after the
software version, Bravo 400S
displays the "Home" (Fig. 25)
screen: press
F8 and enter the
device basic settings (ch. 9).
ORDINARY SWITCHING ON

 
Fig. 27 Fig. 28
After the software version, Bravo 400S
displays the Select User prompt
(Fig. 27)
Press
F7 or F8 to move across the
available items, then press OK to
confirm your selection.
At this point, Bravo 400S displays
the "Home" screen (Fig. 28).
SETUP
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character