ARAG Bravo 400S Crop sprayer - Manual (Page 36)

36
AUTOMATIC SECTION CONTROL
Fig. 112
• Sections overlapping limit
Set the acceptable threshold for overlapping of already-sprayed areas.
When this value is exceeded, Bravo 400S restores the correct spraying: depending on the section
management mode enabled (par. 12.4 Boom section management), Bravo 400S will prompt the operator to
close the relevant valves or proceed to the automatic closing of boom sections.
Sections overlapping limit 0% Sections overlapping limit 100 %
0%
Fig. 113
100%
Fig. 114
Fig. 115
• Perimeter overlapping limit
Set the acceptable threshold for overlapping of spraying with respect to field perimeter.
When this value is exceeded, Bravo 400S restores the correct spraying:
according to the activated section management mode (par. 12.4 Boom section management), Bravo 400S
will notify the operator that the section valves spraying outside the field perimeter must be opened or
closed, or it will perform the automatic opening / closing of the boom sections.
The following conditions are required in order to use this setup:
- Drawing the field perimeter (red line in the figures) using the function F4 Surface (par. 15.4).
- Enabling section automatic management: the icon on the guidance screen indicates that
automatic management is enabled.
Perimeter overlapping limit 0% Perimeter overlapping limit 100%
The alert asking to close / open section valves will be displayed following a mini-
mum overlapping (0%) across the field perimeter. The alert asking to close / open section valves will be displayed ONLY when the
machine is spraying across the entire field perimeter (100%).
FIELD
PERIMETER
Fig. 116
FIELD
PERIMETER
Fig. 117
CONTINUES > > >
ADVANCED SETUP "IMPLEMENT"
Par.
7.4
Exits the function
or data change Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Increase /
Decrease
of data Scroll
(UP /
DOWN) Enter
selected
character