ARAG Bravo 400S Crop sprayer - Manual (Page 5)

5
1 RISKS AND PROTECTIONS BEFORE ASSEMBLY
All installation works must be done with battery disconnected, using suitable tools and any individual protection equipment
deemed necessary.
Use ONLY clean water for treatment tests and simulations: using chemicals during simulated treatment runs can seriously injure
persons in the vicinity.
2 INTENDED USE
The device you have purchased is a computer which, when connected to a valve or suitable control unit, makes it possible to control all phases of
treatment in agricultural applications directly from the cabin of the farming machine it is installed in.
BRAVO 400S features a satellite navigator that – through the external GPS receiver – can be used for agricultural applications and navigation.
BRAVO 400S is not designed for use on public roads and should only be used on farmland.
This device is designed to work on agricultural machinery for spraying and crop spraying applications.
The machine is designed and built in compliance with EN ISO 14982 standard (Electromagnetic compatibility - Forestry and
farming machines), harmonized with 2004/108/EC Directive.
3 PRECAUTIONS
• Do not aim water jets at the equipment.
• Do not use solvents or fuel to clean the case outer surface.
• Do not clean equipment with direct water jets.
• Comply with the specified power voltage (12 VDC).
• In case of voltaic arc welding, remove connectors from BRAVO 400S and disconnect the power cables.
• Only use ARAG genuine spare parts and accessories.
• Bravo 400S can control hydraulic valves to open / close the boom.
The computer does not feature emergency stop devices: the manufacturer must provide all necessary safety devices for the
hydraulic boom control.
Any time one hydraulic boom section is opened or closed the computer emits an acoustic signal and the display shows the
relevant indication. The manufacturer should also provide acoustic and optical warnings in the vicinity of the boom.
4 PACKAGE CONTENT
The diagram below indicates the components that you will find in the BRAVO 400S computer package:
BRAVO 400S
Fig. 1
Legend:
1 Bravo 400S
2 Instruction manual
3 Remote Control Unit (RCU) complete with harness
3a Connection cable to the oil-hydraulic unit
3b Connection cable to the control unit
3c Connection cable to power supply and sensors
3d Connection cable to monitor
4 Monitor - switch box connection cable
5 Fixing kit
6a Oil-hydraulic valve connector seals
6b Section valve connector seals
7 Power supply connector
INTRODUCTION