ARM Electronics XR&HD480 OSD - Manual (Page 13)

User’s Manual
12
„ Software
The item identifies the software version installed on this unit.
„ DSP
This item identifies the digital signal processor (DSP) number of the unit.
„ MAC Address 1
This item identifies the first Media Access Control (MAC) address of the unit.
„ MAC Address 2
This item identifies the second MAC address of the unit.
„ Software Upgrade Via Local Device
This item is used for upgrading software of the Premium H.264 DVR by local
device. The menu is displayed as follows.
Software Upgrade via Local Device
Upgrade Version
xxxx-xxxx-xxxx-xxxx Select
No
Connect an USB drive containing upgrade software to the unit, then the
available upgrade files will be listed in the menu. To update the system, select
a file and use UP / DOWN keys to choose <Yes>. Press ENTER to confirm
the selection and start the upgrade process. The Premium H.264 DVR loads
the software, updates the system files, and reboots automatically.
The upgrade may take several minutes to save the changes in the memory of
the system. After the unit is rebooted, please check the software version
again.
NOTE:
No power interruption is allowed during the software update.
Ensure that no power interruption can occur until the unit is completely
rebooted.
NOTE
: Do not remove the external USB ThumbDrive ® / DVD+RW
before the unit has completely shut down (hard drive and fan are off).
Removing the external USB ThumbDrive
®
/ DVD+RW before shut
down can cause the system to update improperly.