ARM Electronics XR&HD480 OSD - Manual (Page 45)

User’s Manual
44
Camera Setup
The items in the Camera Setup menu enable users to set camera parameters, including
camera title, dome protocol and ID for each connected camera. Note that there will be
separated menus for analog cameras and IP cameras. Please refer to <Analog Camera>
section if users are setting an analog camera, or refer to <IP Camera> when users are
setting an IP camera.
< Analog Camera >
If users are using an analog camera, please continue with this section. Items in this menu
are described in the following subsections.
Analog Camera
Analog Camera Select
Dome Protocol
Dome ID
Camera Title
Covert/Privacy Mask
Termination
Brightness
Contrast
Saturation
Hue
Audio Association
Copy Settings CH3
None
0
Ch3
On
-0
0
0
0
Yes
„ Analog Camera Select
The item is used to select a camera for setting it’s parameters. The related
settings will follow the selected camera, such as dome protocol and camera
title. Move the cursor to <Analog Camera Select> and press ENTER, then
select a channel using UP / DOWN keys.
„ Dome Protocol
Select the communications protocol associated with the user’s dome camera
using ENTER and Direction keys.
„ Dome ID
This item is used to assign an ID number (0 to 255) to the selected dome
camera. Note that ID number must match the ID address set by the dome
camera.