Configuring ipv6 netstream aggregation data export – H3C Technologies H3C SR8800 User Manual
Page 174
162
To configure IPv6 NetStream traditional data export:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the destination
address for the IPv6
NetStream traditional
data export.
ipv6 netstream export host
ip-address udp-port [ vpn-instance
vpn-instance-name ]
By default, no destination address is
configured, in which case, the IPv6
NetStream traditional data is not
exported.
3.
Configure the source
interface for IPv6
NetStream traditional
data export.
ipv6 netstream export source
interface interface-type
interface-number
Optional.
•
By default, the interface connecting
to the NetStream server is used as
the source interface.
•
H3C recommends you connect the
network management interface to
the NetStream server and configure
it as the source interface.
4.
Limit the data export rate. ipv6 netstream export rate rate
Optional.
By default, the data export rate is not
limited.
Configuring IPv6 NetStream aggregation data export
Before configuring the IPv6 NetStream traditional data export, enable IPv6 NetStream first.
To configure IPv6 NetStream aggregation data export:
Step Command
Remarks
1.
Enter system view. system-view
N/A
2.
Set an IPv6
NetStream
aggregation
mode and enter
its view.
ipv6 netstream aggregation { as
| destination-prefix | prefix |
protocol-port | source-prefix |
bgp-nexthop }
N/A
3.
Configure the
destination
address for the
IPv6 NetStream
aggregation data
export.
ipv6 netstream export host
ip-address udp-port
[ vpn-instance
vpn-instance-name ]
By default, no destination address is configured
in IPv6 NetStream aggregation view. Its default
destination address is that configured in system
view, if any.
If you expect to export only IPv6 NetStream
aggregation data, configure the destination
address in related aggregation view only.