Nqa collaboration configuration example, Network requirements, Configuration procedure – H3C Technologies H3C SR8800 User Manual
Page 61
49
# Stop the DLSw tests after a period of time.
[DeviceA] undo nqa schedule admin test
# Display the result of the last DLSw test.
[DeviceA] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 19/19/19
Square-Sum of round trip time: 361
Last succeeded probe time: 2007-11-22 10:40:27.7
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of DLSw tests.
[DeviceA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 19 Succeeded 2007-11-22 10:40:27.7
NQA collaboration configuration example
Network requirements
As shown in
, configure a static route to Router C on Router A, with Router B as the next hop.
Associate the static route, track entry, and NQA test group to verify whether the static route is active in
real time.
Figure 18 Network diagram
Configuration procedure
1.
Assign each interface an IP address. (Details not shown)
2.
On Router A, configure a unicast static route and associate the static route with a track entry.
GE3/1//2
10.1.1.1/24
GE3/1//1
10.1.1.2/24
GE3/1//1
10.2.1.1/24
Router C
GE3/1//1
10.2.1.2/24
Router B
Router A