Configuration prerequisites, Configuring voice tests – H3C Technologies H3C SR8800 User Manual
Page 36
24
Configuration prerequisites
Voice tests require cooperation between the NQA server and the NQA client. Before you start voice tests,
configure a UDP listening service on the NQA server. For more information about UDP listening service
configuration, see “
Configuring voice tests
To configure voice tests:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3.
Configure the test type as
voice and enter test type view. type voice
N/A
4.
Configure the destination
address of voice probe
packets.
destination ip ip-address
By default, no destination IP
address is configured for a test
operation.
The destination IP address must be
the same as that of the listening
service on the NQA server.
5.
Configure the destination port
of voice probe packets.
destination port port-number
By default, no destination port
number is configured.
The destination port must be the
same as that of the listening service
on the NQA server.
6.
Configure the codec type.
codec-type { g711a | g711u |
g729a }
Optional.
By default, the codec type is
G.711 A-law.
7.
Configure the advantage
factor for calculating MOS
and ICPIF values.
advantage-factor factor
Optional.
By default, the advantage factor is
0.
8.
Specify the source IP address
of probe packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
9.
Specify the source port
number of probe packets.
source port port-number
Optional.
By default, no source port number
is specified.