H3C Technologies H3C SR8800 - Manual (Page 194)

182
Step Command Remarks
4. Configure the channel through
which system information can
be output to the log buffer and
specify the buffer size.
info-center logbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
Optional.
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is 512.
5. Configure the output rules of
the system information.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap
{ level severity | state state }* ]*
Optional.
See “
Default output rules of system
information .”
6. Configure the format of the
timestamp.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the SNMP module
NOTE:
The SNMP module receives the trap information only, and discards the log and debugging information
even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network management
station (NMS). In this case, you need to configure to send traps to the SNMP module, and then set the
trap sending parameters for the SNMP module to further process traps. For more information, see the
chapter “SNMP configuration.”
To configure to output system information to the SNMP module:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 7 for default channel
names.
4. Configure the channel through
which system information can
be output to the SNMP module.
info-center snmp channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).