Configuring snmp tests, Configuration prerequisites – H3C Technologies H3C SR8800 User Manual
Page 32
20
Step Command
Remarks
11.
Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
is timed out.
probe packet-timeout
packet-timeout
Optional.
3000 milliseconds by default.
12.
Configure the source IP
address for UDP jitter packets. source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
13.
Configure optional
parameters.
See “
parameters for an NQA test
group
Optional.
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The probe
packet-number command specifies the number of probe packets sent in each UDP jitter probe operation.
Configuring SNMP tests
SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.
Configuration prerequisites
Before you start SNMP tests, enable the SNMP agent function on the device that serves as an SNMP
agent. For more information abut SNMP agent configuration, see the chapter “SNMP configuration.”
Configuring SNMP tests
To configure SNMP tests:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3.
Configure the test type as
SNMP and enter test type
view.
type snmp N/A
4.
Configure the destination
address of SNMP packets.
destination ip ip-address
By default, no destination IP
address is configured.
5.
Specify the source port of
SNMP packets.
source port port-number
Optional.
By default, no source port number
is specified.